In addition to oil leakage, jump resistance, oil explosion and other problems, smoking electronic cigarettes will also encounter paste core. We all know that the newly made core needs to be moistened with soot before use, so that the cotton can absorb enough soot. Direct dry burning of cotton will definitely paste the core, cotton at high temperature may also lead to heat silk carbon accumulation; In this way, not only the cotton needs to be re-worn, but also the coil has to be re-wound, which is very troublesome, so how should the electronic cigarette paste core be done? Xiaobian from the following 6 aspects to teach you to solve.
First, choose a good VAPE oil
The VG/PG value of the fume oil is also an important factor leading to the core paste. VG is glycerol, and the fluidity is worse than PG. Therefore, the smoke oil with high VG content will cause the oil conduction speed to decrease, and the atomization speed will be greater than the oil conduction speed, which will cause dry burning. In addition, Malay oil generally tastes sweet, which is the reason for its high sugar content; High sugar content is prone to carbon accumulation, which leads to core burning. Therefore, to avoid the paste core caused by the soot problem, you need to choose a higher VG content of the soot, or reduce the frequency of use. Of course, the cold weather will also lead to the poor fluidity of the liquid, especially the peppermint flavor of the liquid, which will lead to the paste core; Therefore, I heard that players in the north need to use their love for Vape to “influence” the smoke oil.
Ii. Power
The power is high, the corresponding atomization speed will also increase, the oil guide speed will not change, sorry, or paste the core. This situation can be solved simply by reducing the power. However, when the power is constant, the jump may also lead to core paste, which is related to the proficiency of the player’s DIY. At the same time, when DIY silk is done, the coil is not handled perfectly, or the coil is deformed by wearing cotton, which will lead to uneven heating and lead to core paste.
Third, the use of time
Atomizing core also has a life, too long use time will also appear a lot of “health” problems, such as carbon deposition. Carbon deposit is generally attached to the heat on the black material, carbon deposit will directly affect the taste; It will also further lead to the emergence of paste core phenomenon. Generally, the heating wire produces carbon deposits and needs to be re-made.
Four, atomization core
The vast majority of the paste core is caused by no smoke oil, poor cotton oil conductivity, large viscosity of smoke oil, uneven heating, etc., can be avoided in normal use. Pay more attention to the changes in the atomization core, and the proficiency of DIY will naturally improve.
5. atomizing core moistening core
Before using the finished atomizer core, the atomizer core should be moistening the core, and the soot can be repeatedly dropped three times in the top and around the place where the cotton can be seen. After the atomizer is filled with the soot and installed, the atomizer should rest for about 15 minutes to allow the cotton to fully absorb the soot, which can prevent the paste of the core.
6. Uneven heating
The heating is not uniform, that is, one to two heating coils are hot especially fast, and it will be easier to paste the core. Make a good heating coil must be burned, so as to ensure uniform heating.
The above is the solution of electronic cigarette paste core, according to the above 6 points can effectively avoid electronic cigarette paste core, hope to help you.