ANYCUBIC Wash & Cure 2.0 Now For Just €84.99 Inclusive of VAT

The Anycubic Wash & Cure 2.0 is a post-processing station for Anycubic Photon/Photon S. This washing and drying station helps clean and dry prints to make them cleaner and more durable, and automates part of the cleaning which is normally done manually.

Buy ANYCUBIC Wash & Cure 2.0 at €84.99 on CAFAGO

Design

The ANYCUBIC Wash & Cure 2.0 is used to clean and dry the printed objects to refine the 3D prints based on liquid resin solidified by a UV laser. An operation is recommended when you want to obtain very fine prints of very good quality. The Wash and Cure 2.0 station can wash objects with a maximum volume of 120 x 74 x 165 mm.

Features

The height of the hanger bracket can be adjusted according to the liquid level in the container, allowing each model to be fully cleaned. Open the top hatch, the UV light show will automatically turn off and the device will stop working to ensure safety. Flexible cleaning and curing options: 2min/4min/6min timer for better cleaning and drying of each layer of the 3d printer model according to your needs. Touch button: Easy to use thanks to a sensitive and responsive touch button. The operation is very simple with a knob that allows adjusting the treatment time from 1 to 60 minutes for cleaning and cleaning operations. No other manual action is required to start the treatments.

The washing time can be easily selected using a rotary control and differs depending on the size and degree of soiling of the object to be cleaned. Anycubic provides a table to determine the time. In most cases, it is between two and four minutes, which is enough to remove all resin residues from every print. If that is done, all parts can be easily removed, rinsed briefly underwater, and can then be hardened. Water-soluble resin can also be washed with the Wash & Cure Plus station, the times here are significantly higher at up to 12 minutes.